---
title: Spreading a Dana Differential
description: "This is in reference to recent ARB Air Locker models that suit Dana/Spicer shim adjusted Salisbury axle housings. (Model #s RD100, RD101, RD102, RD103, RD1..."
---

[Skip to content](https://assist.arb.com.au/knowledgebase/spreading-a-dana-differential#main-content)

English - Australia

Show submenu for translations

![](https://assist.arb.com.au/hs-fs/hubfs/ARB_Logo_2022_Black_Horiz_RGB-01-reduced.png?width=300&height=69&name=ARB_Logo_2022_Black_Horiz_RGB-01-reduced.png)

Open main navigation

Close main navigation

- English - Australia
  
  Show submenu for translations
- Contact us

 Contact us

 How can we help you?

- There are no suggestions because the search field is empty.

1. [ARB Knowledgebase](https://assist.arb.com.au/knowledgebase?hsLang=en-au)
2. [PRODUCTS](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au)
3. [FAQ: Air Lockers](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#faq-air-lockers)

# Spreading a Dana Differential

**This is in reference to recent ARB Air Locker models**   
**that suit Dana/Spicer shim adjusted Salisbury axle housings.**  
**(Model #s RD100, RD101, RD102, RD103, RD104, RD105,**   
**RD109, RD113, RD116 & RD117)**

 

It has come to our attention that some of our stockist network has been experiencing difficulty   
when installing some of our recently released Dana/Spicer model differentials which include a   
replacement carrier bearing for both ends of the carrier. *The problem seems to arise from the*   
*necessity of holding a shim pack onto the carrier bearing (RH side or side opposite the air entry*   
*side) while installing the differential assembly to achieve a certain degree of pre-load.*

The newer Air Locker models listed above employ higher rated carrier bearings and heavier   
bearing journal cross sections than were available on the factory designs. **Unfortunately because**   
**of this the Air Locker unit does not support re-using the existing Dana shims which are located**   
**under the bearing cone because the bearing journal diameter of these models is larger than that**   
**of the original model. As a replacement for these, ARB includes a full set of shims to use on the**   
**outside of the supplied bearing cup. The difficulty then seems to lie in squeezing the differential**   
**center into its cavity at the same time as the desired thickness of shim.**

We have investigated this and found that if the assembly has been adequately spread using a   
common differential housing spreader (as detailed in the Air Locker Installation Guide and the   
vehicle manufacturer’s service manual) then no such difficulty exists. Once spread enough to   
accommodate the differential, bearings and shims, an Air Locker can be simply placed into the   
housing by hand.

We are, however, aware that this installation is sometimes attempted without the use of any form   
of differential housing spreader. **This is a practice that ARB cannot support. Dana Spicer and**   
**the vehicle manufacturer explicitly detail the importance of using a differential housing spreader**   
**and demands it of all of their approved service technicians.** These tools are readily available for   
sale at reputable axle service shops, and most designs are adjustable to suit the whole range of   
Dana axle applications. 

![](https://assist.arb.com.au/hubfs/Knowledge%20Base%20Import/19931143590937.png)

During heavy off-road driving, high torque at the axle means that the ring gear on the differential   
carrier can get pushed away from the drive pinion gear with so much force that it partially   
disconnects the two halves of the carrier bearing on the opposite side. *In a factory differential*   
*this temporary misalignment can result in ring and pinion gear damage, as well as carrier bearing*   
*damage to both sides.* **In an Air Locker installation a misalignment condition of this type could**   
**also result in damaged O-rings leading to air or oil leaks.** To combat this the factory equipped   
Dana differential assembly was designed to run with a great deal of tension holding the assembly   
together known as pre-load. You can easily identify this design by the existence of the spreader   
sockets provided.

 

![](https://assist.arb.com.au/hubfs/Knowledge%20Base%20Import/19931150624665.png)

 

Although some fitters may think that by hammering it into a tight fit situation they are still “preloading a differential” – **It is not possible to fully and adequately pre-load a Dana differential using this method. Without the use of a spreader a properly pre-loaded differential is actually too tight to even just remove without difficulty, and next to impossible to refit.**

Spreading a Dana shim type axle assembly will not only reduce the installation time and effort   
required to set up an Air Locker, but it will also allow for the preload necessary to support the   
increased torque demands of off-road use on a locked differential, increase overall bearing life,   
and insure that your Air Locker seals run reliably for many, many years of use.

Attached are some instruction manuals for commercially available differential housing spreaders below for your reference.

![](https://assist.arb.com.au/hubfs/Knowledge%20Base%20Import/19931419995033.png)![](https://assist.arb.com.au/hubfs/Knowledge%20Base%20Import/19931416308249.png)

- [PRODUCTS](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#main-content)

    - [FAQ: Fog Lights](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#faq-fog-lights)
    - [FAQ: Air Compressors](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#faq-air-compressors)
    - [FAQ: Awnings](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#faq-awnings)
    - [FAQ: Driving Lights](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#faq-driving-lights)
    - [FAQ: Suspension](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#faq-suspension)
    - [FAQ: Fridge Freezers](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#faq-fridge-freezers)
    - [FAQ: TRED Recovery Boards](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#faq-tred-recovery-boards)
    - [FAQ: Air Lockers](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#faq-air-lockers)
    - [FAQ: Rooftop Tents](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#faq-rooftop-tents)
    - [FAQ: Jack](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#faq-jack)
    - [FAQ: Outback Solutions Roller Drawers](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#faq-outback-solutions-roller-drawers)
    - [FAQ: Miscellaneous Products](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#faq-miscellaneous-products)
    - [Product Information](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#product-information)
    - [FAQ: Bumpers](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#faq-bumpers)
    - [DIY Instructions: Fitting Advice](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#diy-instructions-fitting-advice)
    - [FAQ: Recovery Gear](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#faq-recovery-gear)
    - [FAQ: Safari Snorkel](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#faq-safari-snorkel)
    - [FAQ: LINX](https://assist.arb.com.au/knowledgebase/products?hsLang=en-au#faq-linx)
- [SELL](https://assist.arb.com.au/knowledgebase/sell?hsLang=en-au#main-content)

    - [MAP Policy](https://assist.arb.com.au/knowledgebase/sell?hsLang=en-au#map-policy)
    - [IN STORES AND ONLINE](https://assist.arb.com.au/knowledgebase/sell?hsLang=en-au#in-stores-and-online)
    - [Distributors](https://assist.arb.com.au/knowledgebase/sell?hsLang=en-au#distributors)
- [BUY](https://assist.arb.com.au/knowledgebase/buy?hsLang=en-au#main-content)

    - [Route Package Protection](https://assist.arb.com.au/knowledgebase/buy?hsLang=en-au#route-package-protection)
    - [ARBUSA.com](https://assist.arb.com.au/knowledgebase/buy?hsLang=en-au#arbusa-com)
    - [STORES](https://assist.arb.com.au/knowledgebase/buy?hsLang=en-au#stores)
    - [MARKETPLACES](https://assist.arb.com.au/knowledgebase/buy?hsLang=en-au#marketplaces)
- [ABOUT ARB](https://assist.arb.com.au/knowledgebase/about-arb?hsLang=en-au#main-content)

    - [FAQ](https://assist.arb.com.au/knowledgebase/about-arb?hsLang=en-au#faq)
    - [MEDIA](https://assist.arb.com.au/knowledgebase/about-arb?hsLang=en-au#media)
    - [TEAM ARB USA](https://assist.arb.com.au/knowledgebase/about-arb?hsLang=en-au#team-arb-usa)
- [WARRANTY](https://assist.arb.com.au/knowledgebase/warranty?hsLang=en-au#main-content)

    - [Warranty Coverage](https://assist.arb.com.au/knowledgebase/warranty?hsLang=en-au#warranty-coverage)
    - [FAQ](https://assist.arb.com.au/knowledgebase/warranty?hsLang=en-au#faq)

Copyright © 2026, ARB Corporation Ltd